I stopped using the EAP for over a year. I have managed to get the OC200 upgraded but there doesn't appear to be a signal from the EAP (despite being connected to a PoE) any advice on getting this act

I'm building a home network with 5 EAP610 and one TL-SG2210 Switch. The gateway will be the ISP's ONT router. I'm deciding whether to buy the hardware controller or not. Considering that this is a sma

Hello, I'm planing to use the Omada Software Controller V5 and a TL-SG1428PE switch together with some EAP access points. I am wondering wether it is possible to turn off PoE power for specific ports

Hi there, I would like to connect a device which works over the network through dchp reservation by reserving the mac address. Id like to use the cpe210 to extend the network using ap mode then reserv

Hi, is there any practical experience on this setting? Can I go as low as 1 second? Will there be any caveat? Where is the tradeoff, longer times obviously means its taking longer to recover from an o

Hi I have an OC200 and the EAP are detecting lots of Rogue AP's (Which I am guessing are being blocked) I have just had a Hive heating system fitted, however the hive components are not communicating,