Hi all, i replaced my home/office network with a complete Omada setup. Fritzbox - Used as modem Omada Controller OC200 ER605 - Gateway currently no firewall settings - 2.0/2.0.1 TL-SG2008P - Switch cu

I just bought this on Amazon (yeah, I know) and I expected that it would be able to connect to the 5G router where I live to get a better connection. However, when I set it up, it only shows the high

Steps followed: (1) Enabled Load Balancer Transmission -> Load Balancing -> Basic Settings -> Enable Load Balancer (2) wrote policy routing rules Transmission -> Routing -> (3) checked routing table w

Hi Has anyone managed to get the ER605 to work with Community Fibre IPv6? Whatever I try, I cannot get it pull at DHCP address. Cheers Gabe

I bought new eap245 device and configured in my network when i am connecting wifi to macbook and apple devices it is giving very slow speed i activated 2.4 and 5 ghz but both bandwidth wifi is very sl

I want to connect the ER7206 with the SFP WAN to my ISP but i dont get an IP. With my old Router i needed to Disable Auto-Negotiation and select Speed/Duplex to Full/1000.Did the ER7206 dont have the