Hi All, I followed instructions from below link: https://www.tp-link.com/pl/support/faq/4017/ Basically I wanted to achieve very same network schema, the only difference is that my Internet Gateway is

We have a device (theatre lighting desk) that uses the ETC Nomad software for remote control / mirroring. Unfortuantely, this software completely lacks the option to point it directly at a target IP,

According to Wikipedia, The United Nations geoscheme is a system that divides 248 countries and territories in the world into six continental regions, 22 geographical subregions, and two intermediary

Any TP-Link Omada Experts Any Omada Experts, I’m struggling to configure secure VLAN ACLs on my TP-Link Omada setup (ER605 router, TL-SG2016P loft switch, TL-SG2218P office switch, OC200 controller) t

Daily disconnection ER605 My configuration: Netgear LB1110 LTE (configured as a modem), gateway ER605 V2 2.2.6 (Build 20240718 Rel.82712), switch TL-SG2428P, 2 EAP225 and the Omada software controller

It would be great to have a feature (as exists on other platforms) that provides an internal (LAN side) virtual NAT, to allow one IP address to exist as virtual IPs on other vlans eg: Say i have a pri