Hi, I have the above gateway with controller duties managed by an onsite OC300. I see some reported CVE issues relating to this model which should be resolved by a firmware update, eg: https://support

I have begun to use switch port labels for grouping ports. I have run into the same issue that I mentioned in a post a week ago in which I receive the message "Some tagged networks configured for the

Hi all, LAN DNS stopped working potentially after upgrading ER707-M2 v1.20 to 1.3.1 Build 20251009 Rel.67687 but cant be sure. I also got the error below in the configuration, confirming that LAN DNS

I just finished setting up a separate management VLAN (10) for the controller, switches, and APs. In the devices list, the gateway is still displayed with its default address (192.168.0.1) but the res

Hi all, I'm quite unfamiliar with ACL settings on Omada devices. I have ER605 Gateway and some SG2008, SG2008P and SG2218 switches. I have a dedicated VLAN 200 for IoT devices and I will to configure

To start off this was a previously working system until about two weeks ago when this issue started. I did not make any changes, but automatic firmware updates were enabled. A power outage did occur a