I’m managing my network with an OC200 + ER7206 + Managed Switch setup. My goal is to access and manage a ZTE router (IP: 10.10.10.254) located in VLAN 10 (subnet 10.10.10.0/24) from my Admin LAN (192.

Note: The switches are actually the SG2008 v4.20 I am experiencing what I perceive as a multicast problem on one of my VLANs. The setup for the VLAN is very simple as shown below: In this configuratio

I attempted to use a simple acl rule to block my cameras from the internet> i set a lan-wan acl rule set to deny all protocols from the ip group that has teh cameras to all ips. I waited 15 min but th

I am a novice in networking but successfully set up the Omada network for home with Er605 and Ss2210 switch, controlled by OC200. Worked perfectly but then controller died and is completely offline. P

Hello all I've added second switch (same model as first one) to my network at home and noticed that switch 2 is using/registering switch one as up link but in reality both switches are connected direc

I updated my router to the last software because i had some problems about "physical disconnection" in my WAN ports. After update to 1.3.6 i have MORE "pysical disconnection ports" even SFP+ and Ether