jra11500LV4Offline
Following: 0Followers: 3
Forums/ Gateways
By Unclebiscuits79 Thursday

ER605 v2 Wireguard Peers Allowed IPs standalone (repost)

Hi there, I am posting this back out there to get some status on this issue. I used the same name from the only issue that I could find on the subject that hasn't been updated since 10/2024 When setti
Forums/ Switches
By Hank21 a week ago

Omada SG_2 Series Pre-Release FW for SDN Controller 6.2.X.X (Released on March, 9th, 2026)

This Article Applies to SG2005P-PD(UN) 1.0, Fully Adapted to Omada SDN Controller v6.2 or above; SG2008(UN) 4.20, Fully Adapted to Omada SDN Controller v6.2 or above; SG2008P(UN) 3.20, Fully Adapted t
Forums/ Requests & Suggestions
By ZoloNN a week ago

Controller still doesn't show ETH0 of EAP615

hi all, in reference to my previous closed post I would like to reopen the issue as it still persists: LLDP is not capable identify the uplink ETH0 port of EAP615: and yes, LLDP is enabled for all dev
Forums/ Controllers
By Vincent-TP a week ago

Hardware Controllers Omada SDN Controller 6.2 Pre-Release Firmware (Update on 13th Mar, 2026)

This Article Applies to OC200(UN)_V1_1.39.7_pre-release (Built-in Omada SDN Controller 6.2.0) OC200(UN)_V2_2.24.7_pre-release (Built-in Omada SDN Controller 6.2.0) OC200(UN)_V3_3.1.2_pre-release (Buil
Forums/ Wireless
By Napsterbater 2 weeks ago

EAP650-Desktop, Broadcast/Multicast bleeding from other VLANs on Wired Port set to Default

If you have the unit using a Mesh uplink (unknown if the issue happens with wired uplink, but I would suspect it would) and a Wired port set to the Default VLAN that port is passing Broadcast and Mult
Forums/ Gateways
By baodrate 2 weeks ago

ER8411 not routing response traffic to wireguard clients

I have wireguard configured on the gateway acting as a VPN server. The "Local IP Address" on the gateway's wireguard config (10.16.16.1) is set to a subnet unused by any of the existing VLANs. There i
123...