Hi, I get new my new AX5400 Wi-Fi 6 Router 2 days ago. After the initial setup, I connect my QNAP 231P NAS via LAN to it and the router starts randomly reboot. 2 days I try to find the problem why the

Good day; I just purchased my Archer AX 50 router yesterday and have been using it most of the day. It is sitting on my desk and I was going to move it to a new location in my office and noticed that

Hi, AX50 claims to have USB3.0 enabled port but my transfer speed is very slow. 20-30 MB/S through wired 1gbps ethernet and 1.5gbps wifi. So basically USB2 speeds. Tried several usb3 hdds and usb3 ssd

The router used to definitely have a lot brighter LED's, now they seem quite faint, even in a dark room. Is there a way to adjust the LED brightness?

Hello, After upgrade from Archer C7 V4 which had some PPPoE - NAT problems, this working wery well except the status page where cpu load and memory usage do not show in real time like C7 does. It refr

Hello, Again about this problem reported on old forums, on this forums and with TP-Link support from Romania. It is about C7 model, not A7. You even did not have this model with any firmware in the li