My Archer VR2800 was working well. But last week it went into Rescue mode. When I switch it on, it boots up and the power LED blinks/flashes continuesly. There is no wifi signal and I cannot connect to it via ethernet cable either. When I unplug it for say 2-3 hours, it works normally again when I switch it on. After reconfiguration, it has to be rebooted and then the cycle begins again: goes into Rescue Mode. I have done the factory default Reset, 30-30-30 Reset, Power recycle, but nothing is helping. The router is less than a year old. I sent email to TP Link Techsuppor, but they do not reply at all, only an automated email acknowleging receipt of incidence.

Any help will be appreciated.

Thanks