Hs100 plugs
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have 4 hs100s connected via kasa and Alexa
They work great, however I have an issue with my tplink modem archer vr900 which occasionally hangs the 2.4 WiFi
When I reboot the WiFi the hs100s never reconnect. I have to manually power them off and on
It's a real pain
Any ideas
Btw, I suspect the plugs are hanging the 2.4 WiFi as it didn't happen before the plugs were configured but it may be a coincidence
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
What about the hardware version and firmware version of the HS100? Do they have the same issue?
What is the led status of the HS100 when they lost connection?
Please ensure that the firmware is up to date and try to customize the wireless settings of the Archer VR900 to optimize the wireless performance, including wireless channel and channel width.
Besides, you can try to setup a static IP for the HS100 via address reservation.
Best regards.
- Copy Link
- Report Inappropriate Content
@Kevin_Z Thanks for your response
I have given the HS100s dedicated IP addresses and the problem of 2.4 network hanging is not as frequent, perhaps a couple of times a week
The plugs all are
Hardware version 2.0
Firmware version 1.5.8
when the wifi network is rebooted (as disabling and re-enabling 2.4 wifi, causes the VR900 to reboot completely)
not all the HS100s reconnect, (wifi led on plug not green) occasionally
I have to power them off and on to reconnect to wifi
- Copy Link
- Report Inappropriate Content
Have you ever tried to change their locations to plug them?
If possible, you can change another wireless network to do a comparison test.
Or you can hard reset the VR900 and the HS100 to give it a go.
Note: After you reset the VR900, you need set it up to get internet unless you back up and restore the configuration file.
Good day.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 762
Replies: 3
Voters 0
No one has voted for it yet.