Tapo C520WS firmware update 1.2.9 failing
I updated the same way to 1.2.8 and older before.
Now the camera is "dead" with only green light visible.
I've tried waiting 2+ hours, only remedy is to shut down the power, it wakes up and works normally, but still on 1.2.8.
I've also tried formatting my SD Card, no change.
Sometimes it says "Installing..." sometimes "Updating..."
Anybody encountering the same behavior?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Resolved by:
hard reset
connecting to mobile hotspot
updating to 1.2.9.
hard reset again to connect to desired SSID (btw this should be improved by allowing us to switch connected device's SSID other than hard resetting it)
now the camera seems to be behaving better
let's see when a new update comes out if I need to do this theatre again
- Copy Link
- Report Inappropriate Content
Firmware 1.2.9 for Tapo C520WS V1 is indeed currently on hold. There should be another updated version of the firmware to cover the update later. For details, please pay attention to the official website product firmware release information.
- Copy Link
- Report Inappropriate Content
Is it a problem with firmware update only? Does the camera encounter any other problem? Such as a problem with viewing the live stream, or playback?
Please go to the Device Info page of your device to check the current firmware version, sometimes there may be a new firmware upgrade reminder even if the upgrade is successful due to app cache or network problem.
If the device does not upgrade successfully, you can try again after restarting the router, camera, and app.
- Copy Link
- Report Inappropriate Content
Hi, like I wrote the update has been unsuccessful, tired multiple times. Device info says 1.2.8 with red circle showing there's an update.
Every time I click update there is a green LED shown on the camera, the recording stops and the update doesn't finish (2+ hours). When I leave the camera menu in Tapo app, it still says firmware update in progress or something like that and doesn't allow me to open the camera menu. RTSP doesn't work either after clicking the update.
When I restart electricity, the camera reboots and starts working again, including RTSP and the Tapo app is prompting me to update the firmware again.
I have not changed anything (such as router and configs, camera placement etc.) since the last firmware update and done at least 3 of them in the past with no such behavior.
- Copy Link
- Report Inappropriate Content
Bump
- Copy Link
- Report Inappropriate Content
Check the signal strength of the camera: go to camera liveview page > Camera Settings -> Device Info -> Tap the signal icon to check the Signal Strength value (RSSI rate). If the signal is weak, move the camera closer to the router.
Strong: more than -50 dBm
Good to Average: among -70 dBm to-50 dBm
Poor: less than -70 dBm
Please send the camera's Mac address to me via pm if the problem persists. And together with the information below:
1. Model of the router.
2. Tapo app version.
- Copy Link
- Report Inappropriate Content
Resolved by:
hard reset
connecting to mobile hotspot
updating to 1.2.9.
hard reset again to connect to desired SSID (btw this should be improved by allowing us to switch connected device's SSID other than hard resetting it)
now the camera seems to be behaving better
let's see when a new update comes out if I need to do this theatre again
- Copy Link
- Report Inappropriate Content
@Snuss my one camera has received it but not other two. I think it is off to distribute now for the rest of the line.
- Copy Link
- Report Inappropriate Content
Firmware 1.2.9 for Tapo C520WS V1 is indeed currently on hold. There should be another updated version of the firmware to cover the update later. For details, please pay attention to the official website product firmware release information.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 2
Views: 578
Replies: 7
Voters 1