P110 energy reading error
Hello everyone, I am having a bit of a debacle over my smart plug p110 regarding its energy reading.
I have the plug attached to my of setup which has a 49" screen and high end pc, combined I know they can suck up to 1000watts, the pc draws 900 peak and the monitor 100 peak with the graphics card alone doing 320-460watts with over clocking now the plug is capping out 123watts after updating it. I've reset it multiple times and doesn't seem to work. What could be the issue?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Try to connect a single appliance only. For safety concerns, it is not recommended to use the Tapo P110 smart plug to control a power strip.
Change a different type of appliance, such as a heater or boiler. Monitor whether the energy reading changes when a new device connected.
- Copy Link
- Report Inappropriate Content
@Pugie image 2 taken at the same time
- Copy Link
- Report Inappropriate Content
Try to connect a single appliance only. For safety concerns, it is not recommended to use the Tapo P110 smart plug to control a power strip.
Change a different type of appliance, such as a heater or boiler. Monitor whether the energy reading changes when a new device connected.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
To assist with this case, a specialist will help to follow it up through email. Please check your inbox later to confirm.
If the email you used to register for the TP-Link community is not your contact email or you cannot access it, please send me your contact email through private message.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 266
Replies: 4
Voters 0
No one has voted for it yet.