Smart Home Community > Tapo Smart Hub > H200 Hub Solid red LED, doesn't respond to reset
< Tapo Smart Hub

H200 Hub Solid red LED, doesn't respond to reset

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

H200 Hub Solid red LED, doesn't respond to reset

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
H200 Hub Solid red LED, doesn't respond to reset
H200 Hub Solid red LED, doesn't respond to reset
2025-02-24 22:41:56 - last edited 2025-03-11 08:17:20
Model: Tapo H200  
Hardware Version:
Firmware Version:

The H200 isn't responding to reset orders, the LED stays Solid red. I have tried various ways of resetting the device. I have tried with and without SD card. I have used various cables, connected it directly to the router and tried via a network switch.

 

Is there any way to fix this issue?

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:H200 Hub Solid red LED, doesn't respond to reset -Solution
2025-02-27 03:19:49 - last edited 2025-03-11 08:17:20

  @Thimo161 

 

  • Disconnect the hub from power for a while, like 20-30mins.
  • Remove SD card and the ethernet cable.
  • Power up the smart hub and wait for 1-2 mins.
  • Reset the smart hub: use a pin to press the reset button - press and hold for about 5-10s. Monitor whether the led indicator shows any changes.

 

If the led indicator still shows no changes, you may contact the retailer or local TP-Link support to proceed warranty for this device. 

▶ Tapo P110M Matter 1.3 Release Energy Monitoring through Matter ▶ Smart HomeBase Tapo H500 - Even More Powerful Smart Hub ▶ First Smart Switch Module! Tapo S112 Smart Switch Module with Roller and Switch Dual Modes ▶ Tapo Camera Image Style & Image Brightness Try out a different image style for your camera!
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:H200 Hub Solid red LED, doesn't respond to reset -Solution
2025-02-27 03:19:49 - last edited 2025-03-11 08:17:20

  @Thimo161 

 

  • Disconnect the hub from power for a while, like 20-30mins.
  • Remove SD card and the ethernet cable.
  • Power up the smart hub and wait for 1-2 mins.
  • Reset the smart hub: use a pin to press the reset button - press and hold for about 5-10s. Monitor whether the led indicator shows any changes.

 

If the led indicator still shows no changes, you may contact the retailer or local TP-Link support to proceed warranty for this device. 

▶ Tapo P110M Matter 1.3 Release Energy Monitoring through Matter ▶ Smart HomeBase Tapo H500 - Even More Powerful Smart Hub ▶ First Smart Switch Module! Tapo S112 Smart Switch Module with Roller and Switch Dual Modes ▶ Tapo Camera Image Style & Image Brightness Try out a different image style for your camera!
Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 460

Replies: 1

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.