Mop - Water not dispensing & bin falling out

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Mop - Water not dispensing & bin falling out

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Mop - Water not dispensing & bin falling out
Mop - Water not dispensing & bin falling out
2025-04-07 07:49:20 - last edited 2025-05-09 07:02:21
Model: Tapo RV30 Max  
Hardware Version:
Firmware Version:

Hi,

 

I have two issues with my RCV30. The water is not dispensing and also the mop gets caught on a flat rug and the bin detaches - which is not a large obstacle - really annoying as it stops the clean until reattached, then happens again a few minutes later.

 

Anyone got any ideas on how to fix. I have ensured air inlet is opening and no obvious blockage to the jets.

 

 How do I claim on warranty etc?

 

 Thanks!

  0      
  0      
#1
Options
1 Accepted Solution
Re:Mop - Water not dispensing & bin falling out-Solution
2025-04-08 03:08:41 - last edited 2025-05-09 07:02:21

  @Slightly 

 

Check the troubleshooting suggestions here. What to do if Tapo robot vacuum doesn't dispense water when mopping?

 

When using the robot vacuum, especially on carpeted areas, please remove the mop if possible. The combination of the mop and carpet increases the friction, which can significantly hinder or completely prevent the vacuum's movement. 

 

What's the type of your carpet? Can you share a picture here?

Tapo P110M Matter 1.3 Release Energy Monitoring through Matter ▶ Smart HomeBase Tapo H500 - Even More Powerful Smart Hub ▶ First Smart Switch Module! Tapo S112 Smart Switch Module with Roller and Switch Dual ModesTapo Camera Image Style & Image Brightness Try out a different image style for your camera!
Recommended Solution
  0  
  0  
#2
Options
3 Reply
Re:Mop - Water not dispensing & bin falling out-Solution
2025-04-08 03:08:41 - last edited 2025-05-09 07:02:21

  @Slightly 

 

Check the troubleshooting suggestions here. What to do if Tapo robot vacuum doesn't dispense water when mopping?

 

When using the robot vacuum, especially on carpeted areas, please remove the mop if possible. The combination of the mop and carpet increases the friction, which can significantly hinder or completely prevent the vacuum's movement. 

 

What's the type of your carpet? Can you share a picture here?

Tapo P110M Matter 1.3 Release Energy Monitoring through Matter ▶ Smart HomeBase Tapo H500 - Even More Powerful Smart Hub ▶ First Smart Switch Module! Tapo S112 Smart Switch Module with Roller and Switch Dual ModesTapo Camera Image Style & Image Brightness Try out a different image style for your camera!
Recommended Solution
  0  
  0  
#2
Options
Re:Mop - Water not dispensing & bin falling out
2025-04-10 16:16:57

  @Wayne-TP the main issue is lack of water. I have tested pump separate from main body, which is fine, contracts are clean. I would suggest it's a software issue...

 

 To be clear - this is a lack of water being pumped. 
 

Do I just send back and get refund or reset - please help.

  0  
  0  
#3
Options
Re:Mop - Water not dispensing & bin falling out
2025-04-11 07:15:47

  @Slightly 

 

Do you have carpet areas created on the map? Double-check the cleaning preference set for the carpet area, the device won't mop the carpet area if it is set to Vacuum only. Feature 6: Carpet Feature -- How to optimize and edit Map of Tapo Robot Vacuum
 

Make sure you have checked everything mentioned in the article provided at #2. If still no help, contact the local support team for further assistance.

Tapo P110M Matter 1.3 Release Energy Monitoring through Matter ▶ Smart HomeBase Tapo H500 - Even More Powerful Smart Hub ▶ First Smart Switch Module! Tapo S112 Smart Switch Module with Roller and Switch Dual ModesTapo Camera Image Style & Image Brightness Try out a different image style for your camera!
  0  
  0  
#4
Options