Downgrade firmware for P110, new version buggy
A new firmware has upgraded some of my Tapo P110 plugs (1.3.4 Build 250403 Rel. 150504). The previous version was 1.3.1 Build 240621 Rel. 162048.
This version causes some problems in a specific case:
I have an automation process which detect a movement from a T100 captor and switch on for 5 minutes a solenoid valve. After this 5 minutes the valve is switched off.
Everything is ok with old firmware but, with the new one, the automation is executed, and few seconds later the T110 plug is reset and need to be reconfigured for the same result at the next execution. Hopefully I've found a plug with the old firmware without this bug. I disabled auto updates for all my Tapo modules.
I think you didn't test every cases. Why don't you begin by a beta test phase before crash our system by these bad upgrade.
Thanks for an urgent fix or a method to rollback my installation.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Beta firmware is available. If you would like to try it, send me a private message with the Mac address of your Tapo P110.
- Copy Link
- Report Inappropriate Content
@McKecks Beta firmware has been sent to your device, you may check it later in the Tapo app and perform the update.
- Copy Link
- Report Inappropriate Content
@jeepcook Sound like I have a similar problem (already posted). No special circumstances with mine, it just reverts back to setup mode after 2 days use.
- Copy Link
- Report Inappropriate Content
@Pinter97 So you did a reset of your plug and now it's ok ?
- Copy Link
- Report Inappropriate Content
@Wayne-TP same issue, does the beta firmware fix it? When will the official firmware release?
- Copy Link
- Report Inappropriate Content
Information
Helpful: 7
Views: 2910
Replies: 37
Voters 1
