@ConorRc 

Tapo D230 doesn't have a direct feature for this scenario, but you could consider the following workaround:

1. Set the H200 as the paired chime of the doorbell (doorbell Device Settings page > Doorbell > Paired Chime) -- make the hub ring when doorbell is pressed.

2. Change the doorbell's wakeup type to 'event detected' (doorbell Device Settings page > Detection > Wake-up sensitivity).

3. Create automation that uses the hub's ringing status to switch the doorbell privacy mode on and off. 

• When H200 Rings
• Then
  1. Send me a notification
  2. Disable D230 privacy mode
  3. Delay 5 minutes <Execute the following action 5 minutes after the above actions start. The time specified here indicates how long you want the doorbell to stay on after disabling privacy mode. However, the actual recording duration is mainly influenced by the activity in front of the doorbell.  For instance, if you set it for 5 minutes but no one is present after one minute, the doorbell will automatically enter sleep mode for the remaining time until the delay countdown finishes, at which point privacy mode will be reactivated.>
  4. Enable D230 privacy mode

☆ How to create Smart Action (Automation or Shortcut) on Tapo app