Tapo H100 after power outage
Hi,
The Hub does not recover 100% after power cut.
Devices linked are connected again when router is avaliable again, but not send events, for example if you have a Tapo T110 sensor you will see it connected but don't send events open-close.
If you manually unplug Hub h100 and reconnect everything back to normal.
I think is some kind of issue to have to wait until the router is available.
Please is there any way to resolve it?
Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Could you please clarify whether you are referring to the sensor's inability to properly record the open/close logs, or that the automation settings related to the sensor are not being executed? If it's the latter, as the automation mainly replies on the cloud, if the smart device hasn't successfully connected to the cloud, the automation won't run.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Do you have other sensors that are connected to the same hub? Do you have similar issues? May i know what are the hardware and firmware versions of your Tapo T110?
- Copy Link
- Report Inappropriate Content
I have 16 devices connected, all of them with the same issue: T110, T300, T100, T315....
T110 Build Info, Hw v 1.0
1.9.0 Build 230704 Rel.154531
Regards
- Copy Link
- Report Inappropriate Content
To assist with this case, a specialist will help to follow it up through email. Please check your inbox later to confirm.
If the email you used to register for the TP-Link community is not your contact email or you cannot access it, please send me your contact email through private message.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 304
Replies: 6
Voters 0
No one has voted for it yet.