Default camera view setting
I have 3 660s installed. How can I set a new default position setting. They each keep reverting to the factory setting and I lose the view I want.
I have tried to set an image as per what I think are the instructions but there is no "set" or "save" option at any stage.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
The camera’s “default position” is defined as the viewing angle from your last live viewing session. After a tracking ends, the camera will return to this default position. If you adjust the camera’s viewpoint, whether manually or via automation, its default position will update accordingly.
- Copy Link
- Report Inappropriate Content
The camera’s “default position” is defined as the viewing angle from your last live viewing session. After a tracking ends, the camera will return to this default position. If you adjust the camera’s viewpoint, whether manually or via automation, its default position will update accordingly.
- Copy Link
- Report Inappropriate Content
My c660 will regularly generate its own default position. So if i then direct it to a saved favourite position this is based on an incorrect start and my final position is off.
My camera will regularly be found facing the wall. That's not much good as a security camera.
- Copy Link
- Report Inappropriate Content
Goosewing wrote
My c660 will regularly generate its own default position. So if i then direct it to a saved favourite position this is based on an incorrect start and my final position is off.
My camera will regularly be found facing the wall. That's not much good as a security camera.
Are you facing an issue described here? FYI. What to do if the Tapo Pan/Tilt camera can't return to its original position properly after tracking
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 252
Replies: 3
Voters 0
No one has voted for it yet.