H200 Cannot connect to wifi after firmware update.
Yesterday one of my Tapo H200 hubs received new firmware version 1.61. It cannot connect to wifi in a correct way since that update. I already factory reset the hub and reconfigured it using an ethernet cable.
Symptoms:
- Cannot configure hub over wifi after reset. App sais this firmware version does not support wireless configuration. Also Hub does not show up as wifi access point
- Hub can be added using ethernet cable connected to router
- When connected with ethernet cable, I can connect to wifi
- When I remove ethernet cable, led flashes and goed back to green. Connection to wifi works
- When I disconnect power and reconnect power, hub does not connect to wifi. Led stays orange.
I cannot move the hub back to its original position in the garage where not ethernet is available. It refuses to connect after disconnected from power.
My other hub is on firmware 1.6.0 and still has connection.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
@MaartenK After the last firmware update of my H100 killed the "matter", it honestly no longer surprises me that the H200 has various bugs. It seems like they're very sloppy in testing before releasing updates.
- Copy Link
- Report Inappropriate Content
Andreas75 wrote
@Wayne-TP Hello, Yes, the problem is identical. The latest firmware 1.7.1 is installed. The error remains, however. New problems were added with version 1.7.1. But that's a different topic.
Your case seems to require further investigation. To assist with this case, a specialist will help to follow it up through email. Please check your inbox later to confirm.
If the email you used to register for the TP-Link community is not your contact email or you cannot access it, please send me your contact email through private message.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1928
Replies: 22
Voters 0
No one has voted for it yet.