H500 - smart action inconsistent HUB control

H500 - smart action inconsistent HUB control

H500 - smart action inconsistent HUB control
H500 - smart action inconsistent HUB control
3 weeks ago - last edited 2 weeks ago
Model: Tapo H500  
Hardware Version: V1
Firmware Version: 139 Build 20251218

Using TAPO S200B  V 1.0, Firmware  1.112.09 BUild 231121

 

I have two automations controlled by one S200B button.

 

Single click turns three lights on.

Double click turns the same three lights off.

 

The ON automation has the house logo indicating under Local HUB control.

 

The OFF automation does not.

 

Both created at the same time

So WHY does the same device NOT have both automations under local HUB control

  0      
  0      
#1
Options
1 Accepted Solution
Re:H500 - smart action inconsistent HUB control-Solution
3 weeks ago - last edited 2 weeks ago

  @Sheepless 

 

Which Tapo smart bulb did you use? This solution might help, check it out. Fixes: Cannot Create Local Smart or Local Smart Suddenly Inactive

CES 2026 Meet TP-Link AI Assistant and More New Products!
Recommended Solution
  0  
  0  
#2
Options
2 Reply
Re:H500 - smart action inconsistent HUB control-Solution
3 weeks ago - last edited 2 weeks ago

  @Sheepless 

 

Which Tapo smart bulb did you use? This solution might help, check it out. Fixes: Cannot Create Local Smart or Local Smart Suddenly Inactive

CES 2026 Meet TP-Link AI Assistant and More New Products!
Recommended Solution
  0  
  0  
#2
Options
Re:H500 - smart action inconsistent HUB control
3 weeks ago

  @Sheepless 

I think I comply with all the points in that article.

 

The light bulbs controlled are 2 x L530 and 1 x L510.

 

 

I also have a smart plug P100 that has an On and an OFF automation.  Again both created at the same time. The OFF one is on the hub the ON one is not.

 

I have 20 plus automations and these are the only TWO that have been created Local.  Many of the others were pre hub install.

 

 

  0  
  0  
#3
Options