@gulluwing_1- 

Did you disable the sensor's own notification feature? You may check it in their Device Settings page.

Additionally, your automation settings seem a bit odd. Did you know that when you add multiple conditions under “When,” the automation will run if ANY one of them is met? For example, in your first setup, the automation will trigger — sending a notification — whenever you leave home or when the motion sensor detects movement. This means even if you’re at home, movements detected by the sensor can still activate the automation and send a notification. Is that what you intended?

gulluwing_1- wrote

  @gulluwing_1- 

I would like that when I am not at home and 1 hour after sunset Tapo would send me a notification that the sensor has detected movement

  @gulluwing_1- 

To achieve the scenario you described, you’ll need to set up two separate automation rules. For example, to receive a notification when motion is detected only after you’ve left home or after sunset, you can configure them like this:

Rule A – Motion notification

• Trigger: when the sensor detects motion → Action: send notification.
• Effective time: as needed

Rule B – Enable Condition

• Trigger: 1. when you leave home; 2. 1 hour after sunset
• Action: enable Rule A
• Effective time: Always.

This way, Rule A will only run when you’re away or after it’s been dark for an hour, ensuring you only get motion notifications during those times.

  @gulluwing_1- Did you disable the notification feature on the sensor itself? You can check it on their Device Settings page.