Default Password on TPlinkTPCamera invalid

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2019-05-18 17:47:12 - last edited 2021-11-17 01:24:25

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2019-05-18

Default Password on TPlinkTPCamera invalid

2019-05-18 17:47:12 - last edited 2021-11-17 01:24:25

Model: NC450

Hardware Version:

Firmware Version:

TPLink Philippines, can you provide the default password for the NC450, your default password is not working.

1 Accepted Solution

2019-05-21 01:53:14 - last edited 2021-11-17 01:24:22

Posts: 21600

Helpful: 5047

Solutions: 2545

Stories: 21

Registered: 2018-12-24

Re:Default Password on TPlinkTPCamera invalid-Solution

2019-05-21 01:53:14 - last edited 2021-11-17 01:24:22

Hi,

The default password is admin, which is printed on the bottom label of the camera itself.

If it does not work, you can hard reset by holding the reset button/hole.

Below is the instruction to configure the NC450.

Good day.

Nice to Meet You in Our TP-Link Community. Check Out the Latest Posts: Connect TP-Link Archer BE550 to Germany's DS-Lite (Dual Stack Lite) Internet via WAN Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller. Archer AX90 New Firmware Added Support for EasyMesh and Ethernet Backhaul If you found a post or response helpful, please click Helpful (arrow pointing upward icon). If you are the author of a topic, remember to mark a helpful reply as the "Recommended Solution" (star icon) so that others can benefit from it.

Helpful: 0

Replies: 1