Auto-tracking is detected and follows the subject, but not until a certain angle.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Auto-tracking is detected and follows the subject, but not until a certain angle.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Auto-tracking is detected and follows the subject, but not until a certain angle.
Auto-tracking is detected and follows the subject, but not until a certain angle.
2024-03-20 01:08:31 - last edited 2024-03-28 03:35:07
Model: Tapo C520WS  
Hardware Version: V1
Firmware Version: 1.2.6

Hi there,

 

I noticed my cctv tracking well initially in a 10 meter distance and until I reach a certain point, which is 1 meter from my main door, and the location of the cctv is 1 meter on my right, mounted to the wall about 9 feet from the floor. I am seeking your advice and assistance.

 

Thank you.

  1      
  1      
#1
Options
1 Accepted Solution
Re:Auto-tracking is detected and follows the subject, but not until a certain angle.-Solution
2024-03-20 10:33:05 - last edited 2024-03-28 03:35:07

  @ShahE 

Hi,
You can refer to the instructions below to improve the tracking effect of the camera.
How to improve the motion tracking effect of my camera?
Best Regards

Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Auto-tracking is detected and follows the subject, but not until a certain angle.-Solution
2024-03-20 10:33:05 - last edited 2024-03-28 03:35:07

  @ShahE 

Hi,
You can refer to the instructions below to improve the tracking effect of the camera.
How to improve the motion tracking effect of my camera?
Best Regards

Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 1

Views: 422

Replies: 1

Related Articles