NC200 Keeps going offline and sound problems
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
NC200 Keeps going offline and sound problems
Model :
Hardware Version : Not Clear
Firmware Version :
ISP :
Hei.
I have read the other post on this. and the post about checking if its registered correct, it does not solve this...
My NC200 Keeps going offline (Router D-Link dir 655)
When the NC200 Goes online again, if it does, the following recordings cant be viewed. they are about 127 Kb.
If and when i log into the camera from the app, when its active recording, the scheduled and the following recordings is not viewable from the computer that its set up to record
They end up being the same as described....
In many of my recordings when i play them, theres no sound. The sound is there, checked with different programs as AVICodec. VLC and more.....
When i check out the codec info on sound, this is what i get from a file with NO sound playable
In a file where there is sound
Theres a difference here...what is going wrong here, its not a codec issue !
AND YES, sound is turned on(volume control) in camera control panel !!
Hoping for a solution.
Regards
Warley
Hardware Version : Not Clear
Firmware Version :
ISP :
Hei.
I have read the other post on this. and the post about checking if its registered correct, it does not solve this...
My NC200 Keeps going offline (Router D-Link dir 655)
When the NC200 Goes online again, if it does, the following recordings cant be viewed. they are about 127 Kb.
If and when i log into the camera from the app, when its active recording, the scheduled and the following recordings is not viewable from the computer that its set up to record
They end up being the same as described....
In many of my recordings when i play them, theres no sound. The sound is there, checked with different programs as AVICodec. VLC and more.....
When i check out the codec info on sound, this is what i get from a file with NO sound playable
Type: Sound - Codec: PCM U8(araw) - Samplingspeed: 8000 Hz - Bit pr Sample:8 - Bitrate: 64 kb/s
In a file where there is sound
Type: Sound - Codec: PCM U8(araw) - Channel: Mono - Samplingspeed: 8000 Hz - Bit pr Sample:8..
Theres a difference here...what is going wrong here, its not a codec issue !
AND YES, sound is turned on(volume control) in camera control panel !!
Hoping for a solution.
Regards
Warley