@Manuel78 Thanks. I'll keep that in mind next time I recommend someone beta firmware for M4(V4). I was under impression only Satellite must be upgraded with beta firmware that needs to be configured...

@LS2509 POE stays for Power Over Ethernet. You will need this only if you garden room does not have electricity. If there is electric outlet in garden room and you have Ethernet cable extended to the...

@Manuel78 As a follow up comment: someone reported that just by upgrading M4 to beta code it now connects to their Satellite instead of Main. Perhaps, that firmware had better understanding and...

@Manuel78 This is beta code, so it is most likely an issue on TP-Link side. Their Support scans forum topics, but just in case please also post about this in the forum topic about M4 firmware:...

@Ufin If your Deco setup is as following: then I would recommend to configure Deco mesh to run in Access Point mode. That will make all Deco nodes use Ethernet for backhaul. See How to set up Deco to...

@Andy737 You can make everything work again, and together with Deco mesh, in two simple steps: 1. Put Virgin hub back to its original mode, which is router mode. Verify that devices connected by...