Ygal_Mizrachi wrote ... my company will take certain commercial decisions. @Ygal_Mizrachi If you plan to deploy Deco mesh in commercial environment, consider the following: 1. You can configure and...

@Penguin1 When you say "disconnect and reconnect," does it mean phone switches to cellular with WiFi signal lost, then back to WiFi, or it stays on WiFi all the time but Internet access is lost...

@Jack4614 In normal situation, you can access Deco mesh settings in Access Point mode and add devices to Deco mesh. I've been running Deco mesh in AP mode for last two years, during that time...

@Samazar There are not very many mobile devices supporting WiFi 6E yet, so it makes sense to leave it for backhaul for now. After you set your Deco mesh, you can run tests to see if WiFi 6E makes a...

@Samazar 1. Since the XE75 has 3 ethernet ports, can I wire 2 slave modules into the Main (master) module? You definitely can. Also, if you need to connect more wired devices, just connect gigabit...

@PapaJD Sagemcom CS 50001 must be router/gateway. That makes troubleshooting Deco easier. A lot of configuration issues go away, if Deco is configured in Access Point mode. By default, Deco mesh runs...