@JimmyB-Deco Port forwarding is used to allow external devices, on the Internet, connect to internal device, on home network. What you are asking is to have ability for internal device, on home...

@JimmyB-Deco Can you give an example, with generic router configuration, how you could achieve that same thing on it: multiple devices inside to be accessible from the outside on the same port? To...

@LesterAlzaga With what you have, your plan is the best. Replace your Access Point by Deco node, it'll be Main Deco in TP-Link terminology. Run Deco mesh in Access Point mode. Place two remaining...

@tpnovice Just like two separate WiFi routers can coexist in one home, so will two WiFi mesh systems. With obvious headaches of two systems management, WiFi interference and so on. If you could...

@Sparky99 With Deco mesh running in Router mode, that might not be possible. If you are OK running Deco in Access Point mode, which means it'll be connected to ISP router, then there is quite simple...

@putrevu Is is possible you may have defective unit that does not broadcast WiFi signal, for example because of broken antenna. I would recommend the following troubleshooting steps to figure that:...