@lazostat lazostat wrote The printer is 6950 AIO. The printer can only work with IPv6. I have it on dynamic. It is hard to find printer that is exclusively IPv6. I googled specs for your printer...

@PaulS1971 You've got good info and suggestions from @Philbert, I'll add my comments as an owner of Deco M9 Plus set. I have gigabit Internet, too. 1. The Deco speed test shows 742Mbps down and 50...

@RafaelCarvalho Try Access Point mode and if problem does not go away, it might be hardware issue.

@kiddosquall In your case, you can make Main Network 5GHz only, and connect Oculus Quest to it. That should work, because all LAN devices are on Main Network. In Router mode Guest Network is always...

@DaveP67 I may be able to recommend something for WiFi coverage in the house and extension, but I'll need the following information from you first: 1. Do you run Deco mesh in Router mode or in Access...

@MJencek Is it possible your WiFi clients connected to Guest Network? I have pair of M9 Plus, Main is wired and Satellie is connected by WiFi, but I run them in Access Point mode. I can reproduce...