zEnterHackerLV2Offline
Following: 0Followers: 0
Forums/ Wi-Fi Routers
a week ago
Re:Guest networks on Access Points under EasyMesh - how is this supposed to work?
@terziyski I am in e-mail contact with TP-Link Support and have provided them with network topology and configuration files, in order for them to figure out if this is a configuration problem or a...
1HELPFULS
Forums/ Feature Request (Routers)
2 weeks ago
RE:Extend Guest and IoT wifi to Easymesh nodes
@Kevin_Z Kevin_Z wrote zEnterHacker wrote @Kevin_Z Well - I'm not going to change back to router mode for obvious reasons. The complete network structure and IP-addresses are managed by my central...
0HELPFULS
Forums/ Feature Request (Routers)
2 weeks ago
RE:Extend Guest and IoT wifi to Easymesh nodes
@Kevin_Z Well - I'm not going to change back to router mode for obvious reasons. The complete network structure and IP-addresses are managed by my central firewall. I also need full access from wired...
0HELPFULS
Forums/ Feature Request (Routers)
2 weeks ago
RE:Extend Guest and IoT wifi to Easymesh nodes
@fiveV5 As I see it something has been done on AX55 Hardware Version: V1 Firmware Version: 1.5.10 Build 20251119 rel.50509(4555) The Guest network will be propagated from MASTER to the SATELLITE if...
0HELPFULS
Forums/ Wi-Fi Routers
3 weeks ago
Re:Guest networks on Access Points under EasyMesh - how is this supposed to work?
@terziyski Yes but I have given up on trusting TP-Link guest isolation completely, and I just wanted use the guest network to create two designated 2.4GHz and one 5.0GHz SSIDs in order to have more...
0HELPFULS
Forums/ Wi-Fi Routers
3 weeks ago
Re:Guest networks on Access Points under EasyMesh - how is this supposed to work?
@zEnterHacker Waoo!! ... I have done some more digging. If I enable an EasyMeshed Guest Network (You need to enable Traffic Separation for this!) and then connect to this guest network ensuring you...
0HELPFULS
123...