@Vincent-TP When I select Open WebUI from Pharos Control, or I try to go to the devices IP address directly the connection just times out. All I had done was install PharosControl and make the...

@Vincent-TP The CPE was configured, accessible via it's web interface and working fine prior to trying out the ParOS Control Software. Once the PharOS control software discovered the CPE, it could no...

I have a few CPE210's that I use for bridges, and I thought I'd check out Pharos Control software. After realizing it doesn't do anything of value for my specific installation I decided to uninstall...

@Hank21 I'm using Open speed test locally hosted on windows machines at each end of the link (not going through the internet). I'll test with iperf, and see if there is any difference but I doubt it.

@Hank21 The distance between the remote and local AP's is about 250 feet. I did some checking, I set up a local speedtest server on the remote side, and tested from my phone by connecting to the...

I've created a mesh between a wired EAP610-Outdoor, and a remote EAP610-Outdoor. Signal strength is ~62dbi, Tx Rate: 432Mbps+, Rx Rate: 288Mbps+. When I do a speedtest to a local OpenSpeedtest server...