Hi @marfr Thanks for posting in our business forum. Do you have any RADIUS config on the switch?

Hi @dschmitz Thanks for posting in our business forum. dschmitz wrote @Clive_A thanks for your response. When i bought the switch and had a look at the product page under specifications it did not...

Hi @RaRu Thanks for posting in our business forum. RaRu wrote @MR.S Im running it in Docker on NAS - 16Gb of RAM, no limit of memory for that particular docker. I'll have to investigate that then....

Hi @MatheusMoris Thanks for posting in our business forum. If your up and down is the same, then it is likely to be a cable issue. Try a different cable rated CAT5E or above.

Hi @Tom_W_2277 Thanks for posting in our business forum. R600 has ended its firmware support. Ping and tracert on the WAN interface, the test would still use the NAT. But it should have zero effect...

Hi @TIgerVee Thanks for posting in our business forum. Check if your router supports stateful ACL. If it does not support stateful ACL, then it cannot do the unidirectional ACL or a more granular...