lukg20LV1Online
Following: 1Followers: 0
Forums/ Gateways
2025-06-02 15:37:05
Re:ER605 v2 - OpenVPN - No access to network resources after firmware update to 2.3.0
@MR.S I managed to solve it! First, I created an IP Group named OpenVPN_LAN with an address pool matching my OpenVPN subnet. Then, I added a rule allowing WAN IN ➜ LAN traffic for the OpenVPN_LAN...
0HELPFULS
Forums/ Gateways
2025-06-02 15:10:51
Re:ER605 v2 - OpenVPN - No access to network resources after firmware update to 2.3.0
@MR.S The issue has been clarified. Access to network resources via OpenVPN is being blocked by rule 6, which blocks all ports from WAN to LAN. I've always had this rule, and it wasn’t a problem with...
0HELPFULS
Forums/ Gateways
2025-06-02 10:19:43
Re:ER605 v2 - OpenVPN - No access to network resources after firmware update to 2.3.0
I’m not able to send a message to user @Clive_A. Could you possibly notify him about the issue? It might be good for him to be aware of it as well, especially if it turns out to be a firmware bug.
0HELPFULS
Forums/ Gateways
2025-06-02 10:06:13
Re:ER605 v2 - OpenVPN - No access to network resources after firmware update to 2.3.0
"Thank you very much. I'm currently at work, but I'll check it as soon as I get home. Is this a firmware bug? Do you think there might be a solution that would allow me to go back to my existing...
0HELPFULS
Forums/ Gateways
2025-06-02 09:52:35
Re:ER605 v2 - OpenVPN - No access to network resources after firmware update to 2.3.0
I wouldn't want to disable the rules because I have a poor, unsafe ISP. Would you be able to determine which allow rules I could try adding for testing purposes?
0HELPFULS
Forums/ Gateways
2025-06-02 09:41:05
Re:ER605 v2 - OpenVPN - No access to network resources after firmware update to 2.3.0
@MR.S My network pool is 192.168.1.0/24, and the OpenVPN pool is 10.8.0.0/24. I have an ACL allowing incoming traffic on OpenVPN port 1194. Before the update, everything was working perfectly –...
0HELPFULS
12