@Vincent-TP Thank you very much. I found my issue. In my previous configuration with assorted non-Omada switches I had set my trunk port to carry only tagged traffic. My (non-Omada) Router /DHCP...

@GRL I'm not sure what you mean by the wiizard. Here is the process I was using: From factory reset state: 1) Enter the switch management page and configure DHCP and 802.1q vlan. 2) Once the switch...

I am trying to adopt an ES210X-M2 switch to an Omada SDN controller. I can get the controller to adopt on VLAN1 but as soon as I try to configure any other VLANs or switch port configuration, the...

This might be an issue with more than one switch. I spent the weekend trying to setup an ES210X-M2 with the controller. It would adopt, but any changes to the LAN config would take the switch...