rockin, yes that's it exactly. A »Client Isolation« setting was there already until »Guest Network« setting had been introduced. It's no issue for me when features are being introduced for...

Dear forrest, since mymlact didn't reply so far, I'll chime in because we have a similar network setup. The guest network setting installs an (invisible) ACL which denies access to any private IP. In...

@Irakli.k, see this FAQ on how to change the default gateway for T1600G series switches.

CoKro wrote So a few things jump out at me. This firmware is a few versions old. Why doesn't the newer firmware work right? And second, in this case, port 9 should have been tagged, not untagged,...

fdb wrote But since I have you... a bit more info? Two CPE's in the middle is quite doable. But how would they be configured? The one pointing at the source would be a client (right?), cabled to the...

@fdb, it should point to the source CPE and to the destination CPE which is possible only if both are inside the 65º angle of a CPE's antenna beam width. However, you will run into the Hidden Node...