@Airwik, did you set up the OC200 after the factory reset? If not, connect to 192.168.0.253 and use the wizard to set it up. You will be asked by the wizard to enter your TP-Link ID when binding to...

@joergent, works for me. But my network is IPv4 only. What setup do you use?

@geover, you can run the remote (home) CPE in AP Client Router mode. It connects wirelessly to the Office CPE (WAN interface) and works as a router between the WAN and the LAN: See the User's Guide...

rockin wrote Yeah so I tried it both ways. With Guest Network off (what I did above), I can set an ACL to block the same subnet as the network but it appears to only block isolate clients on the same...

rockin wrote I have two macs on the same AP/SSID, and they are able to connect to web and ssh services across eachother. I'm baffed as to why that is. Did you enable »Guest Network«? If so, wireless...

@Irakli.k, please read the FAQ again. The dialog you are referring to is for T1500 series switches, but the FAQ also shows how to proceed for T1600/T2600 series switches. On your switch you go to L3...