@Dxlan, to extend a WLAN to a back yard, you should use an EAP225-Outdoor rather than a CPE. CPEs are for directional links over very long ranges and usually they are used pair-wise for such links....

fdb wrote Because i want to use a WIFI switch on the far end of the second pair, my question was meant to be simply: Can the bridge unit broadcast using the same SSID as the source? Yes, it can do so...

CoKro wrote 1. I'm using Firmware v: 1.0.1 Build 20131023 Rel.33236. Would that matter? 2. Should I change everything that was VLAN1 and create a VLAN10 to replace it across the board? 3. Re: The EAP...

elmado wrote Presumably the controller isn't generating tons of data, but it's still writing data constantly to the disk isn't it? I'm curious if these setups have a limited lifespan, or is it long...

@PC-Dude, do you use shielded CAT5e cables?

@CoKro, go to »Config Tree«, select switch / switch0 / switch-port / interface / eth2 / vlan. Add VLAN 1 and 20 as shown below. Leave PVID empty. This is your trunk port on ER-X now. Ports 1/9/15 of...