Burczymucha wrote The PVID is by default set to 1 and this is what I'm using on all access ports (and to this VLAN belongs all untagged traffic). VLAN 2 is tagged for VoIP on access ports. That's a...

AshleyNL wrote IPv4 Routing Table Refresh Protocol Destination Network Next Hop Distance Metric Interface Name Static 0.0.0.0/24 192.168.2.254 1 0 VLAN70 Connected 192.168.0.0/24 192.168.0.1 0 1...

Hi MarcotteMW, yes, you just connect the EAP110-Outdoor to the LAN of the CPE510. If you have a CPE510 V2 or V3, you connect the LAN ports of the CPE's and EAP's PoE adapters as shown below (be...

@malcoski, works for me. Test done using iperf with default TCP window size of 129 Kbyte running on a MacBook while wirelessly connected to an EAP225: SSID rate limit 10 Kbps upload/download: [ ID]...

Turnspit wrote Normally, if you set static IP address for the EAP, we will not see the AP on the DHCP client of the router. Yes, this is correct, and the EAP devies indeed have static IP addresses. A...

@BruMa, can't work this way. All EAPs need an IP in the mgmt VLAN 200 (10.200.0.0/16). You need to enable »Site Settings → Management VLAN« in OC200 and set its VLAN ID to 200. The port to which the...