M@rius wrote Ok I have sorted this setting also, on your youtube demo of cpr510 you recommend scanning the frequency for quality, in the graphic are 3 lines yellow, red and blue, red an yellow are...

JensKofoed wrote How should the switch be configured to allow tagged packets from the access point to enter at port 2 and exits at port 1, and the replay going back Just enable 802.1Q VLAN mode, add...

lexxai wrote Forgot about it device until new firmware will be. I have same problem, and I use it switch just as unmanaged. I don't understand why TP-Link uses a valid VLAN ID 1 for a default VLAN...

jeb wrote Thanks for that info. If I go that way and get use the 5ghz signal, will devices using that connection through the router in the out building be able to use 2.4ghz also? No, most devices...

jeb wrote I got it all working by choosing the AP Client Router on the 7210, but it's very unstable as far as signal strength. One day it was 32mbs, the first day, and 3 days later the best I see is...

Check on your PC if you get an IP from your router, i.e. if DHCP is working (see network settings). Next try to ping the router. Then try to ping some site on the Internet. If it still does not work,...