@forrest I have 3 VLAN's 1,20 (guest wifi) and 107 (IoT devices). All the EAP's are provisioned identically from the same controller. I've been through the settings for the both the EAP245's, the one...

Setup: two EAP245 V3's and an EAP225-Wall V2 managed by a controller running 3.2.6. One of the EAP245's has never been stable after updating the firmware. If I remember correctly it had 2.2.0 Build...

Earlier this week I noticed new firmware available for the EA245 version 2.3.0. I installed it on both my AP's and had nothing but trouble with clients connecting. They would connect but not get a...

There's no problem with wireless clients. Devices on all 3 SSID's are working fine. The issue is the wired devices attached to the switch on the EAP245 passthrough port. I was thinking about this...

I have a question about EAP 245 VLAN handling on the passthrough port. My config has has 3 SSID's on 3 separate VLAN's. The access point is connected to a TL-SG2210P smart POE switch. I've found that...