Dear @JhonneL, Glad to know that your concern was resolved finally. One tiny thing I would like to mention here. 4. Requested colleuege on nearby place to reset one of the EAP through its adaptor...

Dear @engineerdanc, When I was able to connect to the OC200 (by direct connection) I set it to have a static IP address of 192.168.1.2 With the OC200 plugged into the switch, I can't even ping...

Dear @Lobster4, So the "Mesh" feature is only used with EAP's that are specifically NOT connected via an Ethernet wire? I have a need for exactly that in the lobby area where the signal is a little...

Dear @Snc, Unfortunately the Virgin Media router is supplied by my ISP and so does not support VLANs. I do however have the ability to put the device into modem only mode. I was hoping to do this and...

Dear @Zachar , The TL-WA1201 doesn't support standard PoE, from its specification, it supports passive PoE. https://www.tp-link.com/en/home-networking/access-point/tl-wa1201/#specifications We cannot...

Dear @DoctorJakeRoof, all the lights blink after 8 seconds, but I can't connect to it, via Ethernet or via WiFi (it doesn't show up via WiFi at all). Are there only two LEDs (Power and LAN) lit up on...