Hi Recently I have setup an ac1350 eap 225 access point and an omada 200 controller. Both are wired to my lan switch and the connection showing as wired in my controller software. These work fine Howe

Hello Everyone. I have problem with configuring VLANs on my switch, problem is happening when I'm setting PVID on port. After that the communication with that switch is terribly slow. No matter if I s

I have a Tp-Link Switch model T2600G-28TS, I made 4 VLANs: VLAN_1 (port 1 to 2), VLAN_10 (port 3 to 10), VLAN_20 (port 11 to 20) and VLAN_50 (port 23 to 24) , I have assigned PVID for each port to des

Hi, It is possible the mesh the eap225-outdoor with the eap110-outdoor? And if it's possible, how? Mayby we can mesh the eap225-outdoor with a RE200 extender? THX

I have installed a TP link range extencder and its has great range. I have connected it via a Netgear 1gbps switch to a linkysys router and that is fed by a 900mbps fibre connection. With auto negotia

I know this is a recurring topic, I am following past advice meticulously as far as I can tell. I removed my MacBook from my home network, set a static IP address and have my new CPE210 plugged in to