I recently moved and wanted to install my (omada controlled) EAP245v1 again. If I plug it in now it flashes green-orange-orange-green, and then stays on green. But there is no network to connect to. I

Hello, I enabled backup WAN (primary WAN, backup WAN/LAN1), connection speed statistics have stopped working since then. Where is the mistake? Pavel

Hi All Total newbie here so my apologies if this sounds like a stupid question. I currently have 1 x EAP225 at home that I configured using an app on my iPhone. The EAP is powered by the POE injector

Hello, From what I can tell from the datasheet I should be able to setup and create a mesh network with these AP's. I have mesh enabled in my controller and my AP's adopted and connected. Here are the

Hello together I have the following problem: I have a test environment which are all in the same VLAN (physical server which is connected to port 22). All test servers are virtualized via Hyper-V. The

I've set up my shop such that different areas have different APs and WLAN groups. For example: Area A, EAP A, wlan group A: wifi_shop (default portal/voucher), wifi_otherA Area B, EAP B, wlan group B: