I'm not really sure what happened, all of a sudden my network stopped working this morning. So I upgraded all my devices to the latest firmware and now I'm getting stuck in this adoption loop. With on

trying to configure the sfp+ wan1 port but the port is greyed out in the web broswer standlone settings on the network>wan page. So unable to tick it to enable it is wan. also i was expecting to an op

Adopting EAP in mesh mode is impossible when management VLAN is used for the wired AP, it just fails. It would be great if this issue would get fixed or at least if the omada controller wouldn't allow

Since the installation of the latest firmware 5.1.6 all my EAP225 AP's are making A and AAAA DNS requests for the domain eap225 What exactly is the point of this? I don't have a local network host cal

The PoE injector's green light turns off when inserting the EAP225-Outdoor's Ethernet cable into the PoE port on the injector. Additionally, if you put your ear close to the injector, you'll hear soft

Im managing my network with oc200. I recently clicked on reconnect button under a certain client in my network. Im not sure if it forces the client to reconnect to the network or removes it. Im just c