My setup is as follows: Two WAN links (possibly one more in the future): WAN1: 100mbps WAN2: 2mbps (for OOB and emergency access for 3 computers that need always access for administrative stuff, email

First of all, I am completely new to the world of edge routers. I have dealt with the basic wireless routers for the last several years though so I have some knowledge, just not the amount I need to p

This worked just fine with 5.0.30, but after upgrading to 5.1.7, it has stopped. Signal dBm are no longer reported when scanning for alternate mesh links. See below also, thanks for the1-button upgrad

I have the Omada setup with the ER605 Router, TL-SG2008P PoE Switch and OC200 controller with 3 EAP620-HD's wired for PoE since I do not have power by them. How do I set this up as a mesh or have devi

I have two ISP providers. Vodafone and Movistar. The routers go through a telephony sim and an external antenna. Right now I have the Wan/LAN1 and WAN inputs activated. Connection Type: Dynamic IP TP-

When starting the executable I always get that the website cannot be accessed I try to open: https://localhost:8088/ Instead if I open this other link: https://localhost:8043/61873cb5bd9a34fe6320eXXXX