Hi all I have tplink vr600 and I need tp make it as access point I put the mode on bridge and disabled dhcp Phones are connected without a problem But I can't enter the vr600 page that I put even if I

tp-link AC1200 Wi-Fi Router Dual Band Archer C50 Firmware Version: 0.9.1 0.2 v0001.0 Build 210111 Rel.37983n(4555) Hardware Version: Archer C50 v6 00000001 Model:Archer C50(EU) Ver:6.0 I have CAT5 cab

Hi, I have recently had fibre installed and my ISP provided a Netcomm NF18ACV. This works OK, apart from having very poor Wifi range. The Netcomm connects to the internet WAN using IPOE with no MAC ad

The Archer C7 V4 is listed as a One Mesh supported device on the TP-Link Page: https://www.tp-link.com/us/home-networking/wifi-router/archer-c7/v4/#specifications However, now that I have purchased a

I have just set my router up in router mode. It is wire from my modem..it has been suggested that I should run it in AP mode is just a case off changing the modes and or and change some things in the

I am from Bangladesh. I bought a tp-link router about 2 months ago. While setuping my router, I noticed that there is no option of BANGLADESH in region. I tried in many ways, but couldn't find the sol