HS200 installation

HS200 installation
HS200 installation
Monday
Model: HS200
Hardware Version:
Firmware Version:

I am trying to install the HS 200 to a light switch that controls a power outlet.  The HS 200 has 2 black, 1 white (common) and 1 ground.  The plug has 1 black, 1 white and 1 ground.  The existing switch has both the black and the white connected to it.  Am I safe to think the black is the hot and the white is being used as the passthrough hot?  If so do I connect the HS 200 black to the black, the other HS black to the white, the HS white and ground both to the ground?

0
0
#1
Options
1 Reply
Re:HS200 installation
Monday

@Rconawa 

 

Before connecting anything we would recommend using a touchless volt meter to detect if a line has power on it or not.  for the HS200 you need to have a seperate line and load wire as well as a neutral.  The only wire that is optional is the ground.  If you do not have wiring that meets these requirements the HS200 cannot be used to replace that switch. 

0
0
#2
Options