Archer C3150 SNMP only shows 100MBps

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer C3150 SNMP only shows 100MBps

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Archer C3150 SNMP only shows 100MBps
Archer C3150 SNMP only shows 100MBps
2020-12-14 18:59:49
Model: Archer C3150  
Hardware Version: V1
Firmware Version: 0.9.1 0.1 v005f.0 Build 160707 Rel.64418n

Trying to setup snmp monitoring for my Internet interface. However, when the device is polled it only shows the interfaces at 100MBps. Is this an issue with SNMP? I thgout this was supposed to have Gigbit ports. Any help is appreciated.

  0      
  0      
#1
Options
5 Reply
Re:Archer C3150 SNMP only shows 100MBps
2020-12-14 19:20:16
May be the Ethernet cables. Be sure you are using good quality CAT 5e, 6, or better Ethernet cables. Also some routers and devices have settings that may need to be checked. What speeds do you get if you bypass the router and connect direct to the modem?
  0  
  0  
#2
Options
Re:Archer C3150 SNMP only shows 100MBps
2020-12-14 19:34:42

@ArcherC8 After looking at the info, I am speculating that the letters are important. It says MBps and not Mbps. Large B is Bytes and little b is bits. 100MBps =approx 800Mbps. Not sure yet, I have inquired with PRTG as well.

  0  
  0  
#3
Options
Re:Archer C3150 SNMP only shows 100MBps
2020-12-14 19:52:51

Actullay, after looking again. it says MBits/s. Also, the values getting queried are via SNMP, it has nothing to do with the conneciton, it is what the device is telling SNMP it has. Even unconnected ports indicate 100 MBits/s.

  0  
  0  
#4
Options
Re:Archer C3150 SNMP only shows 100MBps
2020-12-14 19:56:28

I tested with another device that supports 1GB and it shows the proper information (See attached picture). So either this device does not have 1GB ports like it says or the snmp mib vaules are incorrect.

.

  0  
  0  
#5
Options
Re:Archer C3150 SNMP only shows 100MBps
2020-12-15 23:31:44

@tmanstls 

 

If you were to get your computer and connect to the router via Ethernet, does the link speed say gigabit-speed or 100 Mbps?

  0  
  0  
#6
Options