Archer C6 not able to Port Forward or use UPNP.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Archer C6 not able to Port Forward or use UPNP.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Tot1212

2022-12-05 19:19:42 - last edited 2022-12-05 19:20:44

Posts: 2

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-10-20

Archer C6 not able to Port Forward or use UPNP.

2022-12-05 19:19:42 - last edited 2022-12-05 19:20:44

Tags: #Port Forwarding

Model: Archer C6

Hardware Version: V2

Firmware Version: 1.1.8 Build 20210226 rel.34930(5553)

I have an address reservation set in the DHCP but I was told you can still port forward with a Dynamic IP if you do this. I'm can't tell if im in a NAT because my IP matches the one displayed in Status when using an IP Checker but if I do ipconfig I have a 192 ip show up. My firewall is completely off on my PC and my Router itself. Using a Cisco DPC3008 Modem

Archer C6 not able to Port Forward or use UPNP.

Archer C6 not able to Port Forward or use UPNP.

Information

Voters 0

Tags