TP-link
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Good afternoon everyone,
Currently I have the KPN box 12 as a modem with gbit internet, a TL-SF1005P switch with 10/100mbps, then cables to all floors and TP-link Omada AC1200 gigabit wall plate access points (AP). All cables are CAT5e or CAT6.
Directly wired to the modem I get 900mbps. However, via the WiFi and wired via the wall plate access points, I only get 9mbps everywhere. I would expect that I should be able to get 100mbps, given that the switch is 10mbps/100mbps and the APs are gbit.
I've already tried the following, but it doesn't help.
https://www.tp-link.com/us/support/faq/737/
Could you help me further?
These products are all part of our business line of products so you may find better assistance posting on the SMB community: https://community.tp-link.com/en/business. That said the switch itself is a simple unmanaged switch with POE so there isn't much to it. All it does is broadcast traffic to all ports until a device responds and then transmits traffic down that port and line. I haven't had hands-on with this particular switch but the QIG does show that there is a or should be an indicator on it showing if the light is lit then the ports are operating at 10 Mbps. I would assume just on face value of this that that might be the reason for the slow speeds.
