negotiated ethernet speed status
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
negotiated ethernet speed status
Tags:
#Feature Request
Model:
Archer BE550
Hardware Version: V1
Firmware Version: 1.0.7 Build 20240122 rel.39996(5553) BE9300
Hi there.
Can you please fix empty dash for for Tx/Rx rate for ethernet clients in Network Map>Clients web management page?
It shows speeds and signal strenght approximations for Wi-Fi clients but no speed and no info on full/half duplex for Ethernet ones. The router doesn't have leds on ethernet ports and it would be nice to see it in one place instead of investigating each client separately.
The same is for the WAN port, you can force lock negotiated port speed but you can't see speed and duplex status when it's auto-negotiated.
Re:negotiated ethernet speed status
Hi, for the Archer BE550 Ethernet ports status for WAN and LAN, please go to Network Map-> click Archer BE550 device icon, then move to the bottom, you will see Ethernet Status part.
Nice to Meet You in Our TP-Link Community.
Check Out the Latest Posts:
Archer GE550 - BE9300 Tri-Band Wi-Fi 7 Gaming Router
EasyMesh Is Available When Wi-Fi Routers Work in AP Mode as A Controller.
Archer BE550 New Software Enhances System Stability and Optimizes MLO Network Stability.
TL-WA3001 Supports EasyMesh, Speed Limit, Guest Network in AP Mode and/or Multi-SSID Mode.
If you found the post or response helpful, please click Helpful. If an answer solves your problem, click "Recommended Solution" so that others can benefit from it.