Adding Older Deco to New Deco Network

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Adding Older Deco to New Deco Network

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Adding Older Deco to New Deco Network
Adding Older Deco to New Deco Network
2024-03-19 18:46:01
Model: Deco XE75 Pro  
Hardware Version:
Firmware Version:

I have a new DecoX75 Pro system that is operating normally.  I woud like to add a node from a Deco M9 system I was previously using.  However, when the M9 node is powered up, its LED immediately comes on yellow and stays that way, and when I go to the Deco phone app and have it try to add a new node, it finds nothing (no surprise).  I find no reset button one the M9 node.  How do I add this M9 node?

  0      
  0      
#1
Options
1 Reply
Re:Adding Older Deco to New Deco Network
2024-03-19 18:50:24

  @mhguy 

 

The Reset button is on the bottom of the Deco M9 Plus.  It is a pinhole reset button so you will need a paperclip, toothpick, or other reset tool.  Hold the button down for 30 seconds and wait for the light to blink blue.   Once this is the status open the Deco app and tap the "+", choose add a deco, choose the Deco M9 Plus and follow the prompts and you should be good to go.

  0  
  0  
#2
Options